2008 Toyota Tundra 5.7 Camshaft Position Sensor Location
Hey guys im new to the forum but i found everything so helpful.
2008 toyota tundra 5.7 camshaft position sensor location. Thats weird because if it was the actual sensor then your truck wouldnt run. The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. The high resolution is one of the most important inputs by the PCM for fuel control and timing.
The camshaft position sensor senses the retraction of the camshaft intake to identify a particular cylinder. HAD CODES PULLED THREE TIMES AND IT CONTINUES TO CALL FOR A NEW CAMSHAFT POSITION SENSOR. Now the cam sensor runs about 50 or 80 with wire harness and per Toyota labor time is 17 hoursfor somebody that has done this before click on this.
5 Apr 12 2016. How to line up came shaft marks on 2004 47 Toyota tundra. If your Tundra has the P0010 trouble code it will typically not pass the State emissions.
This test monitors the number of high resolution. When the Tundras ECM determines that there is an issue with the signal coming from this sensor itll throw the P0335 trouble code. 11 people found this helpful.
It has 310000 miles on it. This information is used by the Engine Control Module ECM to control ignition and fuel injection. It has the same definition for the Toyota Tundra as it does the Ford Taurus.
Asked by SmoothMRTenn07 Feb 22 2017 at 0252 PM about the 2010 Toyota Tundra Tundra-Grade CrewMax 57L. 2038 Save Share. Anyhow the sensor is behind the timing cover the drivers side cover.