2007 Toyota Tundra 4.7 Secondary Air Injection Pump

Buy online or call toll free.

2007 toyota tundra 4.7 secondary air injection pump. 24 WIRE LOOM PROTECTED CABLE. Ad View Again These Injector Pumps. There are two relays in the 2008 Toyota Tundra that control the secondary injection system.

This video shows the actual replacement of the smog pump and its associated valves in a 2006 Toyota SequoiaTundra. Brought to get fixed and was told by dealer air pump driver needed to be replaced which turned into a secondary air pump valves and associated gaskets. Discussion in 1st Gen Tundras 2000-2006 started by JessiJane06Tundra Oct 27 2018.

2007 Toyota Tundra - Secondary Air Injection Pump Check Valve Bracket. I starter checking on the web and ran across a forum that talked about a bypass kit. Both are located in the engine compartment fuse box under driver side fender next to the battery.

Secondary Air System Air Induction Pump Bypass Kit. If the relay is bad replace it with the same amperage rating relay as the original. It has the following codes P2441 Sec air injection valve bank 1 stuck closed.

I used to have the code for relay valve stuck open bank 2 and the truck was in limp mode. OBD II fault code P0418 is a generic code that is defined as Secondary air injection pump relay A -circuit malfunction and is set when the PCM Powertrain Control Module detects a failure or malfunction in the SAI Secondary Air Injection circuit that is associated with the relay labelled A. Ive read its a typical problem with first gens.

This system requires NO CUTTING OF WIRES and installs in a few simple steps. Module is completely PLUG and PLAY. Toyota warranties 2007 and newer up ccto 150000 miles.