2006 Toyota Tundra Drive Shaft Removal

There are 2 bolts holding it to the truck.

2006 toyota tundra drive shaft removal. Driveshaft broke at the rear yoke. We carry 8 parts in stock ready to ship. All fit 2000-2021 Toyota Tundra and more.

Slide the driveshaft out of the slip yoke. Gently lower the rear of the driveshaft to the ground. Island_Tundra Nov 12 2006.

Toyota has had many safety recalls for driveshaft failures as of 12272018 they have not had a recall on 2010 Tundras. Toyota Tundra center support bearing replacement PART 1 httpsyoutubeWHfbG67Oo8cCenter support bearing replacement on driveshaft PART. The starter is under the intake manifold and takes about 4 hours to take the intake manifold fuel injection.

Next is the carrier bearing. Toyota Tundra Forum. Use a hammer and bang the the end of the driveshaft until it separates from the rear diff.

Buy high quality used 2006 Toyota Tundra Rear Drive Shaft cheap and fast. Remove the front part of the driveshaft. On the front of the driveshaft is a welding mark that is solid and is the best place to hit with the hammer to loosen the driveshaft.

This works for most trucks. Discussion in 1st Gen Tundras 2000-2006 started by Aerindel Oct 18 2019. The easiest way to locate it follow the positive battery cable down to it they are a bear to replace last thing I saw on them was you had to remove windshield wiper arms and all kinds of stuff to get to them heres what a guy listed on his 2006 If your Tundra has a 47 L v8 then be prepared for a long job.