2004 Toyota Tundra Parking Brake Adjustment

Over time the cable can stretch beyond adjustment and under sever stress the cable can snap.

2004 toyota tundra parking brake adjustment. Remove the console covering from around the hand parking brake. 236-horsepower 40L V6 5-speed automatic RWD. Test your adjustment and pull up on the hand parking brake lever.

Parking Brake Cable are shipped directly from authorized Toyota dealers and backed by the manufacturers warranty. Shop OEM 2004 Toyota Part 464100C010 46410-0C010 464100C011. And then the switch for the brake light.

Then the parking brake actuating cable. Was checking brakes for pulsating issue and during inspection they discovered that the right rear caliper had a broken bolt that could not be. If you think they are not adjusted try backing up and applying the brakes every few feet.

While the vehicle was at the dealer being serviced for an unrelated issue the contact was informed that the axle the bearing and the brake backing plate failed. Once the shoes are properly adjusted using the parking brake wont move the adjusting wheel anymore until the brake shoes wear down enough to allow another click of the adjuster. Start by inspectingrepairingadjusting the rear brakes.

Its pretty straightforward and shouldnt take you more than a few hours. Tighten up the adjuster nut till the parking brake pedal has 9-13 clicks to set the brake. Sounds like its time to adjust the parking brake system.

The contact owns a 2008 Toyota Tundra. Parts fit for the following vehicle options. The parking brake lever has an automatic adjusting plate attached to it that rests against the adjuster wheel.