2000 Toyota Tundra Stereo Removal

NOTE - Manual Window Crank Removal.

2000 toyota tundra stereo removal. The factory amp is located below the factory stereo in most Toyotas These are the wire harnesses made to integrate an aftermarket stereo into the factory wire harnesses Toyota has been using these same harnesses since the late 80s Metra 70. The easiest way to remove the stud is to do what most machinists mechanics would do. I just bought my truck used 2017 57L Tundra and the antenna was already broken off.

You will have to un-install the entire antenna system from the inside. 1roll back the two vents in the bezel look closely and there is a phillips head screw on the upper side of each one thats 2 screws. Here thisshould diffently help the 2000-2006 is bout the same remove radio 2000 tundra - Tundra Solutions Forum 2008 Crewmax Black LTD or X-SP Crew max which I dont know havent signed paper work on LTD yet looking hard on X-SP.

The panel is click-fit into the centre console. You gotta remove the kick panel and driver door seel. Note the lighter wiring.

Once the panel is off the radio is held in by 4xcrosshead screws just looking at you. Depress the two clips on each side of the cup holder and pull it out of the cup holder panel. How to remove a stock or aftermarket stereo from a 2001-2007 Toyota Sequoia and 2000-2006 Toyota Tundra.

You can lever it off with a paint scraper. Pull out the sliding cup holder from the center dash panel. I used a sharp spring load punch to center punch the broken surface of the stud.

Needless to say the brackets are exclusively Toyota and fitting a new third party radio. I recommend powering the truck with a 12 volt supply throught the cig or acc socket with an external supply be careful not to short the pos. My ignition switchI think it is the tumbler.