2000 Toyota Tundra Ignition Switch Removal

Press the release bottom with this screwdriver as you pull the lock cylinder straight out.

2000 toyota tundra ignition switch removal. Problems in getting anyone of my keys to turn the ignition. Secure the switch with its screws. You need to replace the starter solenoid contacts or the starter itself.

V6000 milesstop signmy foot of the gas pedal. To remove the ignition switch unfasten its securing screws and withdraw the switch from the lock housing. Auto trans from 1199 moon mist.

No issues or warnings before it went out. Auto trans from 1199 charcoal. It doesnt idle anymore.

Slide the cylinder into the lock housing until the stop. Remove unlock warning switch cable transponder key amplifier and then unlock warning switch. It did exactally what I wanted it to when.

Just remove an ignition coil that you know is good with a good spark plug and hook up to the wire were the bad one was. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing.

While it would seem like the most likely cause for a key to get stuck in the ignition at first compared to it being a bad key this is not nearly as likely. Make sure both the lock cylinder and column lock are in the ACC position. How to video on Toyota Tundra Key lock cylinder removal.